Privacy for your glass, cut to fit.
Frosted window film in the design you choose, made to the exact size of your window or door and delivered anywhere in Canada. Enter your measurements and the price appears immediately.
Plain frost from $6 per square foot. No minimum order.
-
Cut to your exact sizeAny size, from a single small pane upward.
-
Free shipping over $100A flat $25 on smaller orders, Canada-wide.
-
Remake promiseA wrong measurement is remade once at half price.
-
Ready to applySqueegee and step-by-step instructions included.
Where will it go?
Start from a room. Each opens the design tool with a suggested design and size, ready for your own measurements.
Why made to measure
Store-bought film comes in a few fixed sizes and one or two patterns. Ours is made for one piece of glass: yours.
| Feature | FrostFit | Store-bought roll |
|---|---|---|
| Size | Cut to your measurements, to the eighth of an inch | Fixed roll sizes that you cut down yourself |
| Design | More than twenty designs, each adjustable in scale, border and coverage | Plain frost or a small choice of patterns |
| Personal details | House numbers, names and motifs cut into the film | Not available |
| Preparation | Arrives ready to apply, with a squeegee | Measuring, marking and trimming with your own tools |
| What you pay for | The area of your glass and nothing more | A whole roll, including the offcuts |
| Large glass | Supplied in panels with the pattern aligned across each join | Joins and pattern alignment are left to you |
A design for every room
Every design can be resized, given a clear border, limited to part of the glass or finished with a house number. See the full collection
How it works
- 1
Measure the visible glass
Width and height, from edge of glass to edge of glass, in inches or centimetres.
- 2
Design it
Choose a pattern, adjust it and watch the preview at your exact pane size. The price updates with every change.
- 3
We cut and ship
Your film is cut to order, rolled in a protective tube and dispatched within [YOUR TURNAROUND] business days.
- 4
Apply it yourself
Soapy water, the squeegee and about 15 minutes a pane. The film can be repositioned until the water is pressed out.
Clear pricing
Your price is the area of film multiplied by the rate for your design. These examples are produced by the same calculator as the design tool.
A closer look at the film
An etched-glass finish that obscures the view in both directions, day and night, while letting daylight through. It is applied to the inside face of smooth glass and cleans with mild soapy water.
Sample card
See and feel it first
A card with a swatch of the film and every design at reduced scale. $5, mailed free, and credited to your first order.
For business
Offices, clinics and storefronts
List every pane with its own size and design and watch the total build. Add your logo, keep one pattern aligned across a run of glass and choose where the joins fall on large panes. Film is supplied ready for your own team or installer.
Common questions
Ready when your measurements are.
Design and price your windowThe designs
Every design comes in the same etched-glass finish and has its own price per square foot. Choose one to customise it and see the price for your glass.
Design your frosting
Everything on this page is priced automatically. The preview and the price follow each change you make.
For business
Business order builder
Add a line for each pane size. Film prices are calculated immediately. Aligning one pattern across several panes requires a layout from our team, so those orders are sent as a quote request and confirmed within one business day.
- Any number of panesEach with its own size, quantity and design.
- Your logo in the glassCut from vector artwork and checked before production.
- Control over joinsChoose the direction and position on large panes.
- Labelled for fittingEvery piece is marked with its pane name.
The film
One finish, chosen because it looks like sandblasted glass and cuts cleanly into fine patterns.
What it does
Privacy, day and night
The frosted surface blurs shapes on the other side into soft light and shadow. Unlike mirrored film, it works the same after dark with the lights on.
Daylight stays
Frosted film diffuses light without blocking it, so rooms remain bright. Clear areas in a pattern let through a little more view and sparkle.
The look of etched glass
An even, matte white finish with no printed dots or texture, at a fraction of the cost of sandblasting and fully reversible.
Where it works
- Smooth glass in windows, doors, sidelights, shower screens, partitions and cabinet doors.
- Applied to the inside face of the glass, where it is protected from weather.
- Not suitable for textured, patterned or frosted glass, because the adhesive needs a smooth surface.
- For bathrooms, apply to glass that is not under direct, constant spray. [CONFIRM WITH FILM SPEC]
Specification
| Finish | Etched-glass frost, matte |
|---|---|
| Material | [FILM BRAND AND SERIES] |
| Adhesive | [ADHESIVE TYPE], applied wet |
| Expected indoor life | [YEARS FROM FILM SPEC] |
| Largest single piece | 46.5 inches on the shorter side, any practical length |
| Cutting accuracy | [CUTTING TOLERANCE] |
| Removal | [REMOVAL METHOD FROM FILM SPEC] |
Care
Wait a few weeks after fitting before the first clean, so the adhesive can cure fully. After that, use a soft cloth with mild soapy water. Avoid abrasive pads and scrapers, which can mark the surface.
See it before you order
A sample card carries a swatch of the film and every design at reduced scale. It costs $5, is mailed free and is credited to your first order.
Measuring and fitting
Accurate measuring takes five minutes and fitting takes about fifteen minutes a pane. A video guide will sit at the top of this page.
Measuring
- Measure the visible glass only, from the edge of the glass on one side to the edge on the other. Do not include the frame, rubber seal or putty.
- Measure the width at the top, middle and bottom and use the smallest figure. Do the same for the height.
- Enter the figures as measured. There is no need to subtract anything, because the fitting gap is deducted for you.
- Measure each pane separately. Panes that look identical often differ by a few millimetres.
Two ways to fit
Exact fit with a gap
The film is cut 1/8 inch smaller than the glass on each side and goes on without trimming. The fine clear line at the edge is standard for professionally fitted film and allows the water to escape.
Oversize, trimmed in place
An inch is added to the width and the height. You apply the film and trim it against the frame with the knife supplied. This suits older frames that are not perfectly square.
What you need
- The squeegee supplied with your order.
- A spray bottle of water with a few drops of dish soap.
- A lint-free cloth and a glass scraper for paint specks.
Applying the film
- Clean the glass thoroughly, including the corners, and remove any paint specks.
- Spray the glass generously with the soapy water.
- Peel the backing from the film and spray the adhesive side as well.
- Place the film on the glass and slide it into position.
- Squeegee from the centre outward to press the water out.
- For cut designs, wait [YOUR WAIT TIME], then peel the application tape away slowly at a sharp angle.
Large glass supplied in panels
Glass that exceeds 46.5 inches in both directions is supplied as numbered panels. Apply them in order and butt each panel against the last. The pattern is cut to continue across the join.
If a piece does not fit
If a measurement was wrong, we remake the piece once at half price. If the error was ours, we remake it free of charge.
Shipping, returns and remakes
Draft policy for review. The figures you confirmed are shipping at $25 flat, free over $100, and the half-price remake. The rest is proposed wording.
Shipping
| Orders of $100 or more | Free shipping anywhere in Canada |
|---|---|
| Orders under $100 | $25 flat rate |
| Sample cards | Mailed free |
| Production time | [YOUR TURNAROUND] business days |
| Carrier and tracking | [CARRIER], with a tracking number sent by email |
| Packaging | Rolled in a rigid tube with the squeegee and instructions |
Remake promise
Every piece is cut to the measurements entered with the order. If a measurement turns out to be wrong, send the corrected size and we remake that piece once at half price. If we made the error, the remake is free.
Returns
Film is cut to order for one piece of glass and cannot be resold, so it cannot be returned for a refund. Sample cards exist so that you can check the finish before ordering.
Damage in transit
If an order arrives damaged, send a photo of the tube and the film within [NUMBER] days and we will replace it at no charge.
Changes and cancellations
An order can be changed or cancelled until cutting begins. [CONFIRM CUT-OFF]
Help centre
Answers on ordering, measuring, the film, fitting and delivery. If yours is not here, contact us.
About us
FrostFit is made by Galt Signs & Graphics, a sign and graphics shop in Cambridge, Ontario.
Window film is part of our daily work for shops, offices and clinics. FrostFit brings the same film, cutting equipment and care to homeowners and businesses across Canada, with an online tool that prices any piece of glass immediately.
Every order is cut in our own shop by the people who answer the phone. [ADD YOUR STORY: YEARS IN BUSINESS, TEAM, A PHOTO OF THE SHOP]
Contact
| [EMAIL] | |
| Phone | [PHONE] |
| Hours | [HOURS] |
| Shop | Galt Signs & Graphics, Cambridge, Ontario |